| 论文题目 |
刊物名称 |
刊物国家 |
收录情况 |
卷期 |
排名 |
| Effect of oriented fiber membrane fabricated via needleless melt electrospinning on water filtration efficiency |
Desalination |
国外 |
SCI |
344 |
6 |
| Study on Packing Phase Control Based on the Cavity Pressure-Temperature during Injection Molding |
International Polymer Processing |
国外 |
SCI |
(2) |
5 |
| Hydrophilic modification of ultra-fine fibers produced by the melt-differential-electrospinning |
Materials Research Innovations |
国外 |
SCI |
18(S4) |
5 |
| Tug of war effect in melt electrospinning |
Journal of Non-Newtonian Fluid Mechanics |
国外 |
SCI |
202 |
6 |
| Differential Molding System for Micro Injection Molding of Thermoplastics |
International Polymer Processing |
国外 |
SCI |
28(2) |
5 |
| Orthogonal Design Study on Factors Affecting the Degradation of Polylactic Acid Fibers of Melt Electrospinning |
Journal of applied polymer science |
国外 |
SCI |
125 |
4 |
| Interjet Distance in Needleless Melt Differential Electrospinning with Umbellate Nozzles |
APPL. POLYM |
国外 |
SCI |
131(15) |
6 |
| Effect of electric field on gas-assisted melt differential electrospinning with hollow disc electrode |
Journal of Polymer Engineering |
国外 |
SCI |
35(1) |
6 |
| Effect of gate size on the melt filling behavior and residual stress of injection molded parts |
Materials and Design |
国外 |
SCI |
53 |
5 |
| Mass production of ultra-fine fibre by melt electrospinning method using umbellate spinneret |
Materials Research Innovations |
国外 |
SCI |
18(S4) |
6 |
| Heat transfer enhancement in double-pipe heat exchanger by means of rotor-assembled strands |
Chemical Engineering and Processing |
国外 |
SCI |
60 |
5 |
| Heat Flow Analysis and Efficiency Optimization of Rotational Molding Equipment for Large Plastic Products |
International Polymer Processing of the Polymer Processing Society |
国外 |
SCI |
30(2) |
4 |
| Development of internal circulation two-platen IMM for thermoplastic polymer |
Journal of Materials Processing Technology |
国外 |
SCI |
211 |
5 |
| Filling-To-Packing Switchover Mode Based on Cavity Temperature for Injection Molding |
Polymer-Plastics Technology and Engineering |
国外 |
SCI |
50(12) |
3 |
